Positive Crankcase Ventilation – PCV Valve Service at Lewis Complete Auto RepairFebruary 24, 2016

Hello Rowlett! Did you know that the first federally mandated emissions control device was introduced in the 1960’s? The Positive Crankcase Ventilation valve, or PCV valve, has been installed in TX vehicles since 1964 and represents the first legislation by the United States government to regulate harmful emissions as well as to improve in the country’s vehicles.

The PCV valve, as you can probably guess, is located on the crankcase. The crankcase is the lowest part of a vehicle’s engine. It houses the crankshaft and the engine oil. The crankshaft connects to the pistons that power the engine.

Pistons are pushed down when fuel is burned in an engine. This causes the crankshaft to rotate, which sends power to the transmission, which ultimately turns the axles and causes the vehicle to move. Some of the gases released by the burning fuel squeeze around the pistons and down into the crankcase.

If the escaped gases mix with the engine oil in the crankcase, oil sludge develops. This sludge has the consistency of petroleum jelly and can cause damage by clogging up passageways in the engine. Further, escaped gases can build up pressure inside the crankcase that can blow out seals and gaskets.

Before 1964, a hose was attached to the crankcase that vented escaped gases out into the air. These gases contained about 70% unburned fuel, as well as harmful emissions. The PCV valve was designed to curb these harmful emissions as well as recapture unburned fuel.

The PCV valve is a small, one-way valve that allows escaped gases to exit the crankcase. The gases are then routed into the intake system so they can be re-burned in the engine. Fresh air enters the crankcase through a breather tube to facilitate this circulation and keep the air in the crankcase clean.

The PCV valve, like most working parts on a vehicle, will wear out over time. Usually it simply gets gummed up. Preventive maintenance, including routine oil changes at Lewis Complete Auto Repair in Rowlett, will extend the life of the valve, but eventually it will have to be replaced. A sticking PCV valve won’t allow gases to circulate properly, which can increase pressure in the crankcase. Over time, that pressure will lead to oil leaks.

Your vehicle manufacturer recommends that a PCV valve be replaced every twenty to fifty thousand miles, depending on the vehicle and Rowlett driving conditions. It’s an inexpensive repair, but may not be included in the maintenance schedule in your owner’s manual, so if you’re looking for auto advice about the PCV valve, you may have to ask our pros at Lewis Complete Auto Repair.

Taking care of our PCV valves protects the environment in TX, and improves vehicle performance. It’s just part of good car care for Rowlett, and a way that all of us can do our part to improve the world we live in.

 

Lewis Complete Auto Repair
5110 Grisham Dr.
Rowlett, TX 75088
972.475.4800
http://lewis-complete-auto-repair.autotipsvideo.com